![]() ![]() ![]() ![]() What is the difference between the power lines of. The data transfer via USB will only be capable of interfacing with USB 2.0. Now the system will require greater than 100mA, so USB 3.0 interface will need to be used for powering the system. Regarding the setup - the problem is that when I reduce the buffer I get some weird cracking sounds in my sound, so I'm wondering what that means. I am planning on providing a system with the option of powering via USB. can I connect my Motu Ultralite AVB to the thunderbolt port then - so ethernet on the side of the card and then into thunderbolt on my mac? Does this kind of setup even works! Thank you so much! and also to everyone else who replied! Chorus, phaser and flanger, even if mixed 100% wet, will cause issues because whilst they sound "weird" in relation to the dry signal, their output still approximates the dynamic envelope of your live input, so combining them with the latter will constitute a distraction timing will be smeared. That way, as long as you mix the 100% wet signal with your vox and drums, you'll be right as rain. The thing to understand is that latency will be induced it's a matter of how much you can live with. This means that data transfer will occur at 12 Mbps when you connect a USB 2.0 device to a USB 1.1 device, even though the USB 2.0 device is capable of. USB 2.0, which came in 2001, made a leap to Hi-Speed transfer rates of up to 480 Mbits/s. It provides a Low-Speed transfer rate of 1.5 Mbits/s for sub-channel keyboards and mice, and a Full-Speed channel at 12 Mbits/s. Plugging it in a usb3 slot does nothing more. The first official definition, USB 1.0, was introduced in 1996. This is why you will see that USB 3 hard drives are rated as 'faster' in that they transfer a specific amount of data in a faster time. USB 3.0/SuperSpeed: 5 Gbps USB 3.1/SuperSpeed: 10 Gbps When connecting devices with different USB versions, the data transfer rate will be limited by the slowest of the connected devices. Latency wise: Focusrite points out: Scarlett 2nd and 3rd gen all abide by the USB 2 protocol. No buffer setting in your DAW will allow in-line processing sans phase issues, however, if you can live without EQ and compression, parallel time-based effects should be fine. On USB 3 connections a hard drive can push X amount of raw data in a shorter amount of time, as there are more 'lanes' for different packets to travel on. The differences between these figures pale into insignificance when buried in the 50-odd ms you're experiencing at the 1024 buffer setting. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |